The NVX-H7 Pro is the most complete STM32H745 breakout board available. The STM32H745BIT6 comes in a TFBGA240 package — impossible to prototype with on a standard PCB. This board solves that by breaking out every single pin to standard 2.54mm headers, giving you simultaneous access to all six SPI interfaces, four I2C buses, dual FDCAN, SDMMC, DCMI camera interface, and LTDC display controller.
If you have ever needed a peripheral that your eval kit blocked, this is the board for you.
KEY SPECIFICATIONS:
– MCU: STM32H745BIT6 — TFBGA240 package, full pin access
– Cores: Cortex-M7 at 480MHz + Cortex-M4 at 240MHz simultaneously
– Internal Flash: 2MB dual-bank
– Internal SRAM: 1MB + 4KB backup SRAM
– GPIO: Up to 168 GPIOs on 2.54mm headers
– SPI: 6x SPI / I2S
– I2C: 4x I2C
– UART/USART: 4x UART + 4x USART
– CAN FD: 2x FDCAN (ISO 11898-1)
– USB: USB HS (with PHY) + USB FS
– Ethernet: 10/100 Ethernet MAC + RMII
– ADC: 3x 16-bit ADC — 36 channels total
– DAC: 2x 12-bit DAC
– SDMMC: 2x SD/eMMC interfaces
– Camera: DCMI parallel camera interface header
– Display: LTDC TFT LCD controller — RGB interface header
– External Memory: FMC bus header for SDRAM/NOR/NAND
– Debug: JTAG 20-pin header + SWD
– Power: USB-C with onboard power management
USE CASES:
– Complex motor drive systems requiring all SPI + CAN simultaneously
– Machine vision systems with DCMI camera and LTDC display
– Industrial gateways needing full UART + Ethernet + CAN
– Research platforms requiring full peripheral access
– Product prototyping where no compromise on peripherals is acceptable
IN THE BOX:
– NVX-H7 Pro board (hand-assembled and individually tested)
– Pin header set
– Pinout diagram PDF download
– Quick start card
DOCUMENTATION:
Full pinout, schematic, dual-core guide, and example firmware at github.com/nvixeon
Reviews
There are no reviews yet.